Step 1: Place scooter on parking stand (stand is located towards the rear of scooter next to kick starter).
Step 2: Put key into ignition and turn it to the (on) position. Note: Make sure kill switch is in the (on) position.
Step 3: Put unleaded gas into scooter (premium gas recommended). Note: Make sure you have the fuel line connected to the carburetor. It is located on the left side of the bike underneath the seat. There is a compartment that exposes the carburetor and what you are looking for will be either a brass nub 3/4 of an inch long or a hollow nub. You may not see it, however, you should be able to feel it if you are standing on the left side of the bike.
Step 4: Kick start scooter 6-7 times to build compression. Note: Do not pull on throttle or it will flood the carburetor.
Step 5: Now use the electric start (hold in rear left brake lever and press button on right that looks like lightening bolt). Hold for 3-4 seconds. Note: Do not hold it in any longer than 5 seconds at a time or you will burn the starter.
Step 6: Repeat sequence 6-7 times.
Step 7: Once started, adjust idle speed if needed. Note: To adjust idle lift up seat and in engine compartment on the top towards the farthest side of the carburetor, is a Gold Phillip screw attached onto a spring. Turn clockwise until it is set to your preference.